Graco E-10 (heated) 

 

 

   

E-10 Reference Guide.pdf

 

MATERIAL

 APPLICATIONS

High Volume Truck Bedliners, Manufactured Parts, Assembly Line applications, Commercial and Residential Floors, Containment Trailers, Secondary Containment Tanks, Basement Walls, Docks, and more.

ELECTRICAL REQUIREMENTS

  •  E-10 (heated) Max: 120 V, 20 amp

 

COMPRESSOR

  • Minimum 7.5 HP (220 V, 1 phase, 35 amp) two stage with 80-gallon tank capable of 25 CFM @ 100 psi to be used exclusively for equipment only.  Automatic drain is highly recommended.
  • Minimum 10 HP with 120-gallon tank may be necessary if others in the shop will be using air tools simultaneously.

 

REFRIGERANT DRYER

  • The spray air needs to be less than 5% relative humidity as it leaves the gun.
  • A 3-in-1 refrigerant dryer for you compressor is mandatory.
  • Air membrane dryer is mandatory

EQUIPMENT & MATERIAL ROOM (E-10 & E-XP series)

  • Minimum 10ft wide X 10ft long X 8ft high fully insulated walls and ceiling.
  • Recommended to be located next to spray room with common wall to spray area.
  • Heated vents located on 3 corners at bottom of wall 2 ft from the floor.
  • Air intake on 1 corner at bottom of the wall 2 ft from the floor.
  • Heater must be capable of maintaining the room at 80F – 90F 24 hrs a day, 7 days a week.  No open flame heaters.  Radiant or infrared heater with adjustable thermostat works best.
  • A small A/C window unit may be necessary in parts of the country where shop temperatures reach 100F.