Cartridge Gun Spray System
MATERIAL
APPLICATIONS
Truck Bedliners, Trailers, Tool boxes, Floors, Stairs, Walkways, Foam Sculptures, Truck Accessories, Farm Equipment, and more
COMPRESSOR
- Minimum 3 HP (230 V, 1 phase) 2 cylinder with 60-gallon tank capable of 11.3 CFM @ 90 psi to be used exclusively for equipment only. Automatic drain is highly recommended.
- Minimum 5 HP with 80-gallon tank may be necessary if others in the shop will be using air tools simultaneously.
REFRIGERANT DRYER
- The spray air needs to be less than 5% relative humidity as it leaves the gun.
- A 3-in-1 refrigerant dryer for you compressor is mandatory.
- Air membrane dryer is mandatory.
APPLICATION AREA - for truck bedliners only
- One truck: 16ft wide x 16ft deep x 11ft high (minimum)
- Two trucks: 24ft wide x 18ft deep x 11ft high (minimum)
- Flourescent lighting
- Tar paper on floor with duct tape
- Polyethylene curtains capable of completely enclosing spray area (NFPA 701 compliant)
- Ventilation fans must exhaust air 2-3 times per minute. Forced makeup air will be required. Heated air will be needed in colder climates. Note: To determine the CFM of exhaust fan, take total volume of the room and double that number. 3,000 cu ft room will require 6,000 cu ft fan.